Installation

EXTERIOR: FRONT BUMPER: INSTALLATION

1. INSTALL FRONT BUMPER ASSEMBLY (w/o Fog Light)

(a) Engage the 4 claws and install the front bumper assembly.

HINT
Use the same procedure for the RH side and LH side.

(b) Install the clip and 7 screws.

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

HINT
Use the same procedure for the RH side and LH side.

2. INSTALL FRONT BUMPER ASSEMBLY (w/ Fog Light)

(a) Connect each fog light connector, and then install the front bumper assembly.

(b) Engage the 4 claws.

HINT
Use the same procedure for the RH side and LH side.

(c) Install the clip and 7 screws.

(d) Install the screw and pin hold clip.

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

HINT
Use the same procedure for the RH side and LH side.

3. INSTALL RADIATOR GRILLE Installation

4. INSTALL COOL AIR INTAKE DUCT SEAL Installation

5. VEHICLE PREPARATION FOR FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light) Adjustments

6. PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) Adjustments

7. INSPECT FOG LIGHT AIMING (w/ Fog Light) Adjustments

8. ADJUST FOG LIGHT AIMING (w/ Fog Light) Adjustments