Cruise Main Indicator Light Circuit

CRUISE CONTROL: CRUISE CONTROL SYSTEM: Cruise Main Indicator Light Circuit
- Cruise Main Indicator Light Circuit

DESCRIPTION

* The ECM detects a cruise control switch signal and sends it to the combination meter through CAN. Then the CRUISE main indicator light comes on.

* The CRUISE main indicator light circuit uses CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch on (IG).

(c) Turn the Techstream main switch on.

(d) Select the following menu items: Body Electrical / Main Body / Active Test.

(e) Check the CRUISE main indicator light by performing the Active Test.

Combination Meter:





OK:

The indicator light blinks or goes off according to the Techstream operation.

NG -- REPLACE COMBINATION METER ASSEMBLY Removal
OK -- Continue to next step.

2. READ VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch on (IG).

(c) Turn the Techstream main switch on.

(d) Select the following menu items: Powertrain / Cruise Control / Data List.

(e) Check the Data List for proper functioning of the CRUISE main indicator light.

ECM (Cruise control):





OK:

The display changes as shown above according to switch operation.

Result





C -- REPLACE ECM Removal

B -- REPLACE ECM Removal

A -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures