Fuel Injector Circuit

2GR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: Fuel Injector Circuit
- Fuel Injector Circuit

DESCRIPTION

The fuel injectors are located on the intake manifold. They inject fuel into the cylinders based on the signals from the ECM.

WIRING DIAGRAM









INSPECTION PROCEDURE

PROCEDURE

1. CHECK FUEL INJECTOR ASSEMBLY (POWER SOURCE)

(a) Disconnect the fuel injector assembly connector.





(b) Turn the ignition switch on (IG).

(c) Measure the voltage according to the value(s) in the table below.

Standard voltage:





Text in Illustration





(d) Turn the ignition switch off.

(e) Reconnect the fuel injector assembly connector.

NG -- INSPECT FUSE (INJ NO. 2 FUSE)
OK -- Continue to next step.

2. INSPECT FUEL INJECTOR ASSEMBLY

(a) Inspect the injector assembly Testing and Inspection.

NG -- REPLACE FUEL INJECTOR ASSEMBLY Components
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (FIEL INJECTOR ASSEMBLY - ECM)

(a) Disconnect the fuel injector connector (of the misfiring cylinder).





(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (FUEL INJECTOR ASSEMBLY - ECM)

OK -- REPLACE ECM Components

4. INSPECT FUSE (INJ NO. 2 FUSE)

(a) Remove the INJ No. 2 fuse from engine room relay block.





(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:





Text in Illustration





(c) Reinstall the INJ No. 2 fuse.

NG -- REPLACE FUSE

OK -- REPAIR OR REPLACE HARNESS OR CONNECTOR (INTEGRATION RELAY (IG2 RELAY) - FUEL INJECTOR ASSEMBLY)