Programming and Relearning

U151E AUTOMATIC TRANSAXLE: AUTOMATIC TRANSAXLE SYSTEM: INITIALIZATION

1. RESET MEMORY

NOTICE:
* Perform the RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.
* The RESET MEMORY can be performed only with Techstream.
HINT
The ECM memorizes the condition that the ECT controls the automatic transaxle assembly and engine assembly according to those characteristics. Therefore, when the automatic transaxle assembly, engine assembly, or ECM has been replaced, it is necessary to reset the memory so that the ECM can memorize the new information.

Reset procedure is as follows.

(a) Turn the ignition switch off.

(b) Connect Techstream to the DLC3.

(c) Turn the ignition switch on (IG) and push the Techstream main switch on.

(d) Enter the following menu: Powertrain / Engine and ECT / Utility / Reset Memory. Then, press "Next".

(e) Perform the reset memory procedure from the main menu.

CAUTION:
After performing the RESET MEMORY, be sure to perform the ROAD TEST Road Test described earlier.

HINT
The ECM is learned by performing the ROAD TEST.