Installation

AXLE: STEERING KNUCKLE: INSTALLATION

1. INSTALL STEERING KNUCKLE

(a) Using SST and a press, install a new front axle hub bearing to the steering knuckle.





SST : 09950-60020

09951-00810

SST : 09950-70010

09951-07100

2. INSTALL FRONT DISC BRAKE DUST COVER Installation

3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY Installation

4. INSTALL FRONT AXLE HUB HOLE SNAP RING Installation

5. INSTALL NO. 1 FRONT WHEEL BEARING DUST DEFLECTOR Installation

6. INSTALL FRONT LOWER BALL JOINT Installation

7. INSTALL FRONT AXLE ASSEMBLY Installation

8. INSTALL FRONT DRIVE SHAFT ASSEMBLY Installation

9. INSTALL FRONT LOWER SUSPENSION ARM Installation

10. CONNECT TIE ROD ASSEMBLY (for 1AR-FE) Installation

11. CONNECT TIE ROD ASSEMBLY (for 2GR-FE) Installation

12. INSTALL FRONT DISC Reassembly

13. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation

14. INSTALL FRONT AXLE HUB NUT Installation

15. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Installation

16. REMOVE FRONT DISC Disassembly

17. INSPECT FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub

18. INSPECT FRONT AXLE HUB RUNOUT Front Axle Hub

19. INSTALL FRONT DISC Reassembly

20. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation

21. INSTALL FRONT SPEED SENSOR Installation

22. STAKE FRONT AXLE HUB NUT Installation

23. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

24. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT
Inspect and adjust the front wheel alignment Service and Repair

25. CHECK FOR SPEED SENSOR SIGNAL

HINT
Check for speed sensor signals Test Mode Procedure