Back Door Closer Does Not Operate

ENGINE HOOD / DOOR: BACK DOOR CLOSER SYSTEM: Back Door Closer does not Operate
- Back Door Closer does not Operate

DESCRIPTION

The power back door ECU controls the back door closer system. In response to the signals output from the switches related to the back door lock, the back door latch activates the closer motor.

HINT
The back door closer system operates regardless of whether the power back door main switch is ON / OFF.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT BACK DOOR LOCK

(a) Check that the back door fully closes (fully locked) when the door is closed by hand.

NG -- IMPROPER FIT OF BACK DOOR, OR A FOREIGN OBJECT IS STUCK IN BACK DOOR
OK -- Continue to next step.

2. POWER SOURCE RESET

(a) Disconnect the ECU-B fuse and reconnect it. 10 seconds later, check whether the back door closer is operational.

OK -- NORMAL
NG -- Continue to next step.

3. INSPECT BACK DOOR LOCK ASSEMBLY

(a) Check operation of the door lock.

(1) Using a screwdriver, push the latch in order to put the back door lock in the locked condition (full-latch position).

(2) Connect the battery positive (+) lead to terminal 1 and the battery negative (-) lead to terminal 2. Then, check operation of the latch.

OK:

The latch turns to the open-latch position

(3) Inspect motor operation when battery voltage is applied to the terminals.

OK:

(b) Check the back door courtesy switch resistance.

(1) Check the resistance between the terminals of the courtesy switch.

Resistance:

(c) Check the back door latch switch resistance.

(1) Check the resistance between the terminals of the latch switch.

Resistance:

(d) Check the position switch resistance.

(1) Connect the battery positive (+) lead to connector terminal 1 and the negative (-) lead to connector terminal 2.

Resistance:

NG -- REPLACE BACK DOOR LOCK ASSEMBLY
OK -- Continue to next step.

4. CHECK WIRE HARNESS (BACK DOOR LOCK ASSEMBLY - POWER BACK DOOR ECU)

(a) Disconnect the B10 lock and P13 ECU connectors.

(b) Check the resistance between the wire harness side connectors.

Resistance (Check for open circuit):

NG -- REPAIR OR REPLACE HARNESS AND CONNECTOR

OK -- REPLACE POWER BACK DOOR ECU