Body - Moonroof Initialization Procedure
T-SB-0139-09April 29, 2009
Initialization of Moon Roof During PDS
Service Category
General
Section
Pre-Delivery Service
Market
USA
Applicability
Introduction
As a result of the removal of the Short Pin, the "one-touch tilt up and down," "one-touch slide open and close," and "jam protection" functions of the moon roof will be inoperative due to loss of the moon roof position memory.
Initialize the moon roof after installing the Short Pin in its original location during Pre-Delivery Service (PDS).
NOTE
Any time the battery terminal has been disconnected, the moon roof MUST be re-initialized.
Warranty Information
Initialization procedure
1. Cycle the ignition switch to the "IG-ON" position.
2. Push and hold the "TILT UP" side of the switch until the moon roof tilts all the way up and then tilts down slightly (approximately 10 mm [0.4 in.] at rear end).
3. Check for proper operation of the "one-touch slide open and close" and "one-touch tilt up and down" functions by pushing the switch briefly to the "SLIDE OPEN" and "TILT UP" positions.
NOTE
Jam protection function becomes enabled through the above initialization procedure.