Installation

AXLE: FRONT AXLE HUB: INSTALLATION

1. INSTALL FRONT AXLE ASSEMBLY LH

(a) Install the 2 bolts, nuts and front axle assembly LH with the 2 bolts and nuts to the shock absorber assembly front LH.





Torque : 230 Nm (2,350 kgf-cm, 170 ft-lbf)

NOTICE:
* Only when reusing the bolts and nuts, apply the small amount of engine oil to the screw part of the nuts.
* Do not excessively push out the front axle assembly LH.
* Be careful not to damage the outboard joint boot.
* Be careful not to damage the speed sensor rotor.
2. INSTALL FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO.1 LH Installation

3. INSTALL TIE ROD END SUB-ASSEMBLY LH Installation

4. INSTALL FRONT DISC

5. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH

(a) Install the front disc brake caliper assembly LH with the 2 bolts to the steering knuckle LH.





Torque : 104 Nm (1,060 kgf-cm, 77 ft-lbf)

6. INSTALL FRONT AXLE SHAFT LH NUT

(a) Clean the threaded parts on the drive shaft and front axle shaft nut using a non-residue solvent.

NOTICE:
* Be sure to perform this work for a new drive shaft.
* Keep the threaded parts free of oil and foreign objects.
(b) Using a socket wrench (30mm), install a new axle hub LH nut.

Torque : 294 Nm (3,000 kgf-cm, 217 ft-lbf)

7. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY LH

(a) Remove the 2 bolts and separate the front disc brake caliper assembly LH from the steering knuckle LH.

NOTICE:
Use a string or other device to keep the brake caliper from hanging down.

8. REMOVE FRONT DISC

9. INSPECT BEARING BACKLASH Front Axle Hub

10. INSPECT AXLE HUB DEVIATION Front Axle Hub

11. INSTALL FRONT DISC

12. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH

(a) Install the front disc brake caliper assembly LH with the 2 bolts to the steering knuckle LH.





Torque : 104 Nm (1,060 kgf-cm, 77 ft-lbf)

13. INSTALL SPEED SENSOR FRONT LH Installation

14. INSTALL FRONT AXLE SHAFT LH NUT

(a) Clean the threaded parts on the drive shaft and front axle shaft nut using a non-residue solvent.

NOTICE:
* Be sure to perform this work for a new drive shaft.
* Keep the threaded parts free of oil and foreign objects.
(b) Using a socket wrench (30 mm), install a new axle hub LH nut.





Torque : 294 Nm (3,000 kgf-cm, 217 ft-lbf)

(c) Using a chisel and hammer, stake the axle hub LH nut.

15. INSTALL FRONT WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

16. INSPECT FRONT WHEEL ALIGNMENT

(a) Inspect front wheel alignment Service and Repair.

17. CHECK ABS SPEED SENSOR SIGNAL

(a) ABS WITH EBD SYSTEM Test Mode Procedure.

(b) ABS WITH EBD & BA & TRAC & VSC SYSTEM Test Mode Procedure.