Rear Axle Hub

AXLE: REAR AXLE HUB (for 4WD): ON-VEHICLE INSPECTION

1. INSPECT REAR AXLE HUB BEARING BACKLASH

(a) Using a dial gauge, check for backlash near the center of the axle hub.





Maximum:

0.05 mm (0.0020 in.)

(b) If backlash exceeds the maximum, replace the axle hub assembly.

NOTICE:
Ensure that the dial gauge is set at right angles to the measurement surface.

2. INSPECT REAR AXLE HUB BEARING DEVIATION

(a) Using a dial gauge, check for deviation in the surface of the axle hub outside the hub bolt.





Maximum:

0.07 mm (0.0027 in.)

(b) If backlash exceeds the maximum, replace the axle hub assembly.

NOTICE:
Ensure that the dial gauge is set at right angles to the measurement surface.