Reassembly

U151F AUTOMATIC TRANSAXLE: UNDERDRIVE PLANETARY GEAR: REASSEMBLY

1. INSTALL UNDERDRIVE PLANETARY RING GEAR

(a) Install a new snap ring to the outer race of the radial ball bearing rear.





HINT
When replacing the bearing, also replace the counter driven gear with a new one.

(b) Using a piston ring compressor, squeeze the snap ring.





(c) Using SST and a press, press in the outer race of the radial ball bearing rear.





SST : 09950-60020

09951-00890

SST : 09950-70010

09951-07100

NOTICE:
Be sure not to damage the snap ring during outer race installation.

(d) Install the underdrive planetary ring gear to the counter driven gear.





(e) Using a snap ring pliers, install the snap ring.





2. INSTALL UNDERDRIVE PLANETARY GEAR ASSEMBLY

(a) Using SST and a press, press the radial ball bearing rear in the underdrive planetary gear.





SST : 09502-12010

SST : 09950-60010

09951-00260

SST : 09950-70010

09951-07100

NOTICE:
Press the bearing until it becomes flat at the bottom.

(b) Install the counter driven gear with planetary ring gear to the underdrive planetary gear.





(c) Using SST and a press, press in the radial ball bearing front.





SST : 09502-12010

SST : 09950-60010

09951-00260

SST : 09950-70010

09951-07100

NOTICE:
Press the counter driven gear while rotating it.

(d) Using SST and a press, press in the parking lock gear.





SST : 09502-12010

SST : 09950-60010

09951-00260

SST : 09950-70010

09951-07100

NOTICE:
Press the counter driven gear while rotating it.

3. INSTALL DIFFERENTIAL DRIVE PINION

(a) Using SST and a press, press the differential drive pinion.





SST : 09726-40010

SST : 09950-60010

09951-00260

SST : 09950-70010

09951-07100

NOTICE:
Press the counter driven gear while rotating it.

4. INSTALL CYLINDRICAL ROLLER BEARING RACE INNER

(a) Using SST and a press, press the cylindrical roller bearing race inner.





SST : 09506-35010

SST : 09950-60010

09951-00260

SST : 09950-70010

09951-07100

NOTICE:
Press the counter driven gear while rotating it.

5. INSTALL FRONT PLANETARY GEAR NUT

(a) Place the underdrive planetary gear in a soft jaw vise.





NOTICE:
Be careful not to damage the differential drive pinion.

(b) Using a socket wrench, install a new lock nut.

Torque : 280 Nm (2,885 kgf-cm, 207 ft-lbf)

HINT
Use a torque wrench with a fulcrum length of 750 mm (29.53 in.).

(c) Using a pin punch and hammer, stake the lock nut.





CAUTION:
Be sure that there are no cracks on the nut.

6. INSPECT UNDERDRIVE PLANETARY GEAR PRELOAD

HINT
Underdrive Planetary Gear