Clearing Trouble Codes

Actuator Check Connector:

Antilock Warning Light:

1. Turn the ignition off.
2. Disconnect the actuator check connector.
3. Depress the brake pedal 8 or more times within 3 seconds to clear diagnostic codes stored in the computer.
4. Check that a normal code shows on the warning lamp.
5. Connect actuator check connector.
6. Check that the warning light goes off.

Actuator Check Connector:

Super Monitor:

WITH SUPER MONITOR DISPLAY


1. While the display is showing the diagnostic codes, push and hold in the set button and then push the input "H" button and check that the display indication changes to "CLEAR".
2. Hold the buttons until the display indication changes to "OK".
3. Turn the ignition switch off, and connect the actuator check connector.