Part 2
30. REMOVE DIRECT CLUTCH AND FORWARD CLUTCH
a. Remove the direct clutch and forward clutch from the case.
b. Remove the bearing and race.
31. REMOVE SECOND COAST BRAKE BAND
a. Remove the E-ring from the pin.
b. Remove the pin from the brake band.
c. Remove the second coast brake band from the case.
32. REMOVE FRONT PLANETARY RING GEAR
a. Remove the race.
b. Remove the front planetary ring gear from the case.
c. Remove the bearing and race.
33. REMOVE FRONT PLANETARY GEAR
a. Remove the race.
b. With wooden blocks under the output shaft, stand the transmission on the output shaft.
c. Using SST, remove the snap ring.
SST 09350-30020 (09350-07070)
d. Remove the front planetary gear from the case.
34. REMOVE SUN GEAR INPUT DRUM AND ONE-WAY CLUTCH
35. REMOVE FLANGE, PLATES AND DISCS
a. Remove the snap ring.
b. Remove the flange, five discs and five plates.
36. INSPECT DISC, PLATE AND FLANGE
Check that the sliding surface of disc is not worn or burnt. If the disc is worn or burnt, replace all discs. Then check that the sliding surfaces of plate and flange are not worn or burnt.
If necessary, replace them.
37. REMOVE PARKING LOCK ROD
a. Remove the parking lock pawl bracket.
b. Remove the parking lock rod from the manual valve lever.
38. REMOVE PARKING LOCK PAWL AND SHAFT
Remove the spring, parking lock pawl and shaft.
39. REMOVE SECOND BRAKE PISTON SLEEVE
40. REMOVE REAR PLANETARY GEAR, SECOND BRAKE DRUM AND OUTPUT SHAFT
a. Using SST, remove the snap ring.
SST 09350-30020 (09350-07060)
b. Remove the rear planetary gear, second brake drum and output shaft as an assembly.
c. Remove the assembled thrust bearing and race from the case.
41. REMOVE BRAKE DRUM GASKET
Using a screwdriver, remove the gasket.
42. INSPECT TRANSMISSION CASE BUSHING
Using a cylinder gauge, measure the inside diameter of the transmission case rear bushing.
Maximum inside diameter: 38.19 mm (1.5035 in.)
If the inside diameter is greater than the maximum, replace the transmission case.