Manual Valve Lever and Shaft

COMPONENTS

1. REMOVE MANUAL VALVE LEVER AND SHAFT



a. Using a chisel, cutoff the spacer and remove it from the shaft.




b. Using a punch, drive out the pin.
c. Pull the manual valve lever shaft out through the case by the threads.




2. REMOVE OIL SEAL
Using a screwdriver, remove the oil seal.

3. INSTALL NEW OIL SEAL
a. Coat a new oil seal lip with MP grease.



b. Using SST, drive in the oil seal.
SST 09350-30020 (09350-07110)

4. INSTALL MANUAL VALVE LEVER AND SHAFT



a. Assemble a new spacer to the manual valve lever.
b. Install the manual valve lever shaft to the transmission case through the manual valve lever by the threads.




c. Drive in the pin with the slot at a right angle to the shaft.




d. Match the spacer hole to the lever calking hollow and calk the spacer to the lever.
e. Make sure the manual valve lever shaft turns smoothly.