System Check Procedure

PREPARATION
1. Remove the right kick panel.
2. Remove the ECU with wire harness.

EFI SYSTEM CHECK PROCEDURE





NOTE:
^ The EFI circuit can be checked by measuring the voltage at the wiring connectors of the ECU.
^ Perform all voltage measurements with the connectors connected.
^ Verify that the battery voltage is 11 V or above when the ignition switch is ON.

Connectors Of ECU:

Using a voltmeter with high-impedance (10k /V minimum), measure the voltage at each terminal of the wiring connector.

ECU Connector Standard Voltages:

NOTE: If there are any problems, proceed with test indicated in left column.