Installation

INSTALL CYLINDER HEAD BOLTS





The cylinder head bolts are tightened in 3 progressive steps
If any cylinder head bolt is broken or deformed, replace it.
Apply a light coat of engine oil on the threads and under the heads of the cylinder head bolts.





Install and uniformly tighten the 10 cylinder head bolts and plate washers, in several passes, in the sequence shown.

Torque: 39 Nm (400 kgf.cm, 29 ft.lbs.)

If any of the cylinder head bolts does not meet the torque specification, replace the cylinder head bolt.
Mark the front of the cylinder head bolt head with paint.
Retighten the cylinder head bolts by 90° in the numerical order shown.
Retighten the cylinder head bolts by an additional 90°.
Check that the painted mark is now facing rearward.





Install and torque the 2 bolts.

Torque: 21 Nm (210 kgf.cm, 15 ft.lbs.)