System Outline

This system controls the respective brake fluid pressures acting on the disc brake cylinders of the right front wheel, left front wheel, and rear wheels when the brakes are applied in a panic stop so that the wheels do not lock.
This results in improved directional stability and steerability during panic braking.

1. INPUT SIGNAL
(i) Speed Sensor Signal
The speed of the wheels is detected and input to TERMINAL FL+, FR+, RL+ and RR+ of the ABS ECU.

(2) Stop Light SW Signal
A signal is input to TERMINAL STP of the ABS ECU when the brake pedal is depressed.

(3) Deceleration Sensor Signal (4WD)
Longitudinal Acceleration is detected and a signal is input to the ABS ECU.

2. SYSTEM OPERATION
During sudden braking, the ABS ECU which has signals input from each sensor controls the current flowing to the solenoid inside the actuator and lets the hydraulic pressure acting on each wheel cylinder escape to the reservoir. The pump inside the actuator is also operating at this time and it returns the brake fluid from the reservoir to the master cylinder, thus preventing locking of the vehicle wheels.
If the ECU judges that the hydraulic pressure acting on the wheel cylinder is insufficient, the current acting on the solenoid is controlled and the hydraulic pressure is increased.
Holding of the hydraulic pressure is also controlled by the ECU. by the same method as above, by repeated pressure reduction. Holding and increase are repeated to maintain vehicle stability and to improve steerability during sudden braking.