Key to Diagram

Power Window:

A: System Title
B: Indicates a Relay Block. No shading is used and only the Relay Block No. is shown to distinguish it from the J/B.

Example: 1 Indicates Relay Block No. 1.

C: Indicates the connector to be connected to a part (the numeral indicates the pin No.)

Explanation of pin use.

Connector:

The pins shown are only for the highest grade, or only include those in the specification.

D: Connector Color
Connectors not indicated are milky white in color.
E: ( ) is used to indicate different wiring and connector, etc. when the vehicle model, Engine type, or specification is different.
F: Indicates related system.
G: Indicates the wiring harness and wiring harness connector. The wiring harness with male terminal is shown with arrows (V V) Outside numerals are pin numbers.

Wiring Harness Connector:

The first letter of the code for each wiring harness and wiring harness connector(as indicates the component's location, e.g, "E" for the Engine Compartment, "I" for the Instrument Panel and Surrounding area, and "B" for the Body and Surrounding area.

When more than one code has the first and second letters in common, followed by numbers (e.g, IH1, lH2) this indicates the same type of wiring harness and wiring harness connector.

H: Represent a part (all parts are shown in sky blue). The code is the same as the code used in parts position

I: Junction Block (The number in the circle is the J/B No. and the connector code is shown beside it). Junction Block are shaded to clearly separate them from other parts (different junction blocks are shaded differently for further clarification).

Example:

Junction Block:

J : Indicates the wiring color.
Wire colors are indicated by an alphabetical code.

B = Black
BR = Brown
G = Green
GR = Gray
L = Blue
LG = Light Green
0 = Orange
P = Pink
R = Red
V = Violet
W = White
Y = Yellow

The first letter indicates the basic wire color and the second letter indicates the color of the stripe.

Wiring Color:

K: Indicates a wiring Splice Point (Codes are "E" for the Engine Room, "I" for the Instrument Panel, and "B" for Body).

Example:

Splice Point:

The Location of Splice Point I 5 is indicated by the shaded section

L: Page No.
M: Indicates a shielded cable

Shielded Cable:

N: Indicates a ground point
The first letter of the code for each ground point(S) indicates the component's location, e.g, "E" for the Engine Compartment, "I" for the Instrument Panel and Surrounding area, and "B" for the Body and Surrounding area.
O: Indicates the pin number of the connector.
The numbering system is different for female and male connectors.

Pin Number Of The Connector:

P: When 2 parts both use one connector in common, the parts connector name used in the wire routing section is shown in square brackets [ ].