Crankshaft Position Sensor: Service and Repair

REMOVAL
1. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR FROM GENERATOR DRIVE BELT ADJUSTING BAR
2. REMOVE NO.1 TIMING BELT COVER




3. REMOVE CRANKSHAFT POSITION SENSOR
- Remove the bolt and disconnect the crankshaft position sensor.

INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
- Install the crankshaft position sensor with the bolt.

Torque: 9.5 N.m (95 kgf.cm, 82 in.lbf)

2. INSTALL NO.1 TIMING BELT COVER
3. CONNECT CRANKSHAFT POSITION SENSOR CONNECTOR TO GENERATOR DRIVE BELT ADJUSTING BAR