Tightening Specifications
TIGHTENING TORQUESCylinder Head
First Pass 49 Nm (36 ft. lbs.)
Second Pass 90°
Caution: If any of the cylinder head bolts do not meet the torque specification, replace the cylinder head bolt.
Camshaft Bearing Cap
Tighten To 19 Nm (14 ft. lbs.)
Camshaft Timing Gear
Tighten To 54 Nm. (40 ft. lbs.)
Tighten To 37 Nm. (27 ft. lbs.) for SST
Hint: Use a torque wrench with a fulcrum length of 340 cm (13.39).
Intake Manifold
Tighten To 19 Nm (14 ft. lbs.)
Exhaust Manifold
Tighten To 49 Nm. (36 ft. lbs.)
TIGHTENING SEQUENCES
Cylinder Head Bolt Removal Sequence
Cylinder Head Bolt Tightening Sequence
Camshaft Bearing Cap Removal and Installation Sequences
Proper removal and installation procedures are essential to camshaft durability and to avoid damage. Refer to Cylinder Head Assembly; Service and Repair for detailed camshaft removal and installation procedures.