DTC 15

DTC 15 Front Airbag Sensor Assembly (RH) Malfunction




Circuit Description
The front airbag sensor detects the deceleration force in a frontal collision and is located in the front fender on the left and right sides.
For details of the function of each component, see FUNCTION OF COMPONENTS. DTC 15 is recorded when an open is detected in the front airbag sensor circuit.

NOTICE: The front airbag sensor connector is equipped with an electrical connection check mechanism for the purpose of detecting an open in the front airbag sensor. This mechanism is constructed so that when the terminals of the front airbag sensor have been connected (when the connector housing lock is in the locked condition), the connection detection pin on the wire harness side connects with the terminals for diagnosis use on the sensor side. If the connector is not properly connected, the diagnosis system may detect only a malfunction code, even though the SRS is functioning normally. When connecting the front airbag sensor connector, make sure it is connected properly. If DTC 15 is displayed after the front airbag sensor connector has been connected, check again that it is properly connected.




WIRING DIAGRAM

INSPECTION PROCEDURES




1. Preparation




2. Check Front Airbag Sensor Circuit (Measure Resistance Between Terminals +SR, +SL Of Center Airbag Sensor Assembly Connector.)




3. Check Center Airbag Sensor Assembly




4. Check front airbag sensor




5. Check Harness Between Center Airbag Sensor Assembly And Front Airbag Sensor