Input Signal Check

INPUT SIGNAL CHECK







HINT:
- For check No.1 No.2 Turn the ignition switch ON.
- For check No.3
* Turn ignition switch ON.
* Shift to D position.
- For check No.4
* Jack up the vehicle.
* Start the engine.
* Shift to D position.

1. Press the control switch to SET/COAST or RES/ACC position and hold it down or hold it up "1".
2. Push the main switch ON "2".
3. Check that the CRUISE MAIN indicator light blinks twice or 3 times repeatedly after 3 seconds.
4. Turn the SET/COAST or RES/ACC switch OFF.

Indication Code Chart:

6. Operate each switch as listed in the table.
7. Read the blinking pattern of the CRUISE MAIN indicator light.
8. After performing the check, turn the main switch OFF.

HINT: When 2 or more signals are input to the ECU, the lowest numbered code will be displayed first.