Disassembly and Assembly

DISASSEMBLY
1. REMOVE GREASE CAP OR OIL SEAL (INSIDE)
a. Clamp the axle hub in a soft jaw vise.

HINT: Close vise unit it holds hub bolts. Do not tighten it further.

b. 2WD: Using a screwdriver, remove the grease cap.
c. 4WD: Using a screwdriver, remove the oil seal (inside).

2. REMOVE AXLE HUB FROM STEERING KNUCKLE
a. Remove the 4 bolts and shift the brake dust cover towards the hub side (outside).





b. Using SST, remove the axle hub from the steering knuckle.
SST 09710-30021 (09710-03051), 09950-40011 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04030, 09957-04010, 09958-04010)
c. Remove the bearing spacer and ABS speed sensor rotor/ spacer.
3. REMOVE OIL SEAL (OUTSIDE)
Using a screwdriver, remove the oil seal (outside) from the steering knuckle.
4. REMOVE BEARING FROM STEERING KNUCKLE
a. Using snap ring pliers, remove the snap ring.





b. Using SST and a press, remove the bearing from the steering knuckle.
SST 09950-60020 (09951-00810), 09950-70010 (09951-07150)

REASSEMBLY
1. INSTALL NEW BEARING





a. Using SST and a press, install a new bearing to the steering knuckle.
SST 09527-17011, 09950-60020 (09951-00910)
b. Using snap ring pliers, install a new snap ring.

2. INSTALL NEW OIL SEAL (OUTSIDE)





a. Using SST and a plastic hammer, install a new oil seal (outside).
SST 09223-15030, 09527-17011
b. Coat MP grease to the oil seal lip.

3. INSTALL AXLE HUB TO STEERING KNUCKLE
a. Install the brake dust cover to the steering knuckle with the 4 bolts.

Torque: 18 Nm (185 kgf.cm, 13 ft. lbs.)





b. Using SST and a press, install the axle hub to the steering knuckle.
SST 09649-17010

4. INSTALL ABS SPEED SENSOR ROTOR/SPACER

NOTICE: Do not scratch the serration of the speed sensor rotor.

5. INSTALL BEARING SPACER





Using SST and a press, install the bearing spacer.
SST 09950-60010 (09951-00650), 09950-70010 (09951-07150)
6. 2WD: INSTALL GREASE CAP
7. 4WD: INSTALL NEW OIL SEAL (INSIDE)





a. Using SST and a plastic hammer, install a new oil seal (inside).
SST 09527-17011

HINT: Strike the SST on its circumference evenly.

b. Coat MP grease to the oil seal lip.