Wireless Door Lock Control

In this system, the back door ECU receivers weak radio wave transmitted from the transmitter built-into the ignition key, and outputs a signal to the body ECU. Accordingly, all the doors are can be locked and unlocked by remote control.

1. NORMAL OPERATION
* Lock operation
When the lock SW on the transmitter is pressed, all the doors are locked.

* Unlock operation
When the unlock SW on the transmitter is pressed once, only the driver door is unlocked. When the unlock SW is pressed again within 3 seconds, all the doors are unlocked.

2. AUTO LOCK FUNCTION
When the door is not actually opened within 30 seconds after the door has been unlocked by the unlock SW on the transmitter, all the doors are automatically locked. If any of the following conditions are detected, the wireless door lock does not function.
* Any door is opened.
* The ignition key is inserted into the ignition SW.
* When the unlock detection SW of all the doors are locked.

3. WIRELESS DOOR LOCK STOP FUNCTION
If any of the following conditions are detected, the wireless door lock does not function.
Lock operation
* When any door is open (Door courtesy SW ON)
* The ignition key is inserted into the ignition SW (Unlock warning SW ON)
* Ignition SW is ON

Unlock operation
* Ignition SW is ON

4. BUZZER SOUND FUNCTION
During lock operation, when the back door ECU receives a lock signal from the door unlock detection SW, the wireless door lock buzzer goes on once. During unlock operation, when the back door ECU receives an unlock signal from the door unlock detection SW, the keyless buzzer goes on twice.

With any door open, when the back door ECU receives a lock signal from the transmitter, the keyless buzzer goes on for approx. 10 seconds. If the door is closed, or ignition SW is ON, or if the unlock signal is received from the transmitter while the buzzer is ON, the buzzer stops.

5. VISUAL CONFIRMATION OF LOCK OR UNLOCK
During lock operation, when the back door ECU receives a lock signal from the door unlock detection SW, the taillight and front parking light is flashed once. During unlock operation, when the back door ECU receives an unlock signal from the door unlock detection SW, the taillight and front parking light is flashed twice.

6. PANIC MODE FUNCTION
When the panic SW ON the transmitter is pressed, the back door ECU receives a signal and enters the panic mode. The signal input into the body ECU from the back door ECU turns ON (during 60 seconds) the theft deterrent horn, the horn LH and RH, and flashes the front parking light, taillight and headlight. When the panic SW or the unlock SW of the transmitter is pressed during the panic mode, the panic mode is canceled, and the theft deterrent horn, the horn LH and RH stop, and the front parking light, taillight and headlight are turned OFF.

7. REPEAT FUNCTION
If the lock detection signal in response to the output signal is not received after the back door ECU has output the lock signal, the lock signal is output again.

8. BUZZER VOLUME CONTROL
The volume of the keyless buzzer can be set among 5 steps by operating the transmitter, when the ignition SW is OFF, any door open, and the ignition key is not in the ignition key cylinder.

9. BACK WINDOW CONTROL
When the ignition SW is OFF, the ignition key is not inserted into the ignition key cylinder, the back window can be opened by pressing the back window open SW of the transmitter for approximately 0.8 seconds. At that time, the keyless buzzer beeps once.