Oil Seal

REPLACEMENT





1. IF NECESSARY, REPLACE FRONT BEARING RETAINER OIL SEAL
a) Using a screwdriver and hammer, drive out the oil seal.
b) Using SST and a hammer, drive in a new oil seal until its surface is flush with the retainer upper surface.
SST 09950-60010 (09951-00590), 09950-70010 (09951-07100)
c) Coat the lip of the oil seal with MP grease.





2. IF NECESSARY, REPLACE FRONT CASE OIL SEAL
a) Using a screwdriver and hammer, drive out the oil seal.
b) Using SST and a hammer, drive in a new oil seal until its surface is flush with the case upper surface.
SST 09316-60011 (09316-00011)
c) Coat the lip of the oil seal with MP grease.





3. IF NECESSARY, REPLACE EXTENSION HOUSING OIL SEAL
a) Using a screwdriver and hammer, drive out the oil seal.
b) Using SST and a hammer, drive in a new oil seal until its surface is flush with the housing upper surface.
SST 09554-22010
c) Coat the lip of the oil seal with MP grease.





4. IF NECESSARY, REPLACE FRONT AND REAR COMPANION FLANGE OIL SEALS
a) Using a screwdriver and hammer, drive out the 2 oil seals from the 2 flanges.
b) Using SST and a hammer, drive in 2 new oil seals.
SST 09950-60010 (09951-00220, 09951-00350, 09952-06010), 09950-70010 (09951-07100)
c) Coat the lip of the oil seal with MP grease.





5. IF NECESSARY, REPLACE SHIFT FORK SHAFT OIL SEAL
a) Using a screwdriver, pry out the 2 oil seals.
b) Using SST and a hammer, drive in 2 new oil seals.
SST 09304-12012
Oil seal drive in depth: -0.5-0.5 mm (-0.020-0.020 inch)
c) Coat the lip of the oil seal with MP grease.