Wiper and Washer Systems: Service and Repair
REMOVAL1. REMOVE WIPER ARMS
2. REMOVE WEATHERSTRIP
NOTE: Do not strongly pull off the weatherstrip as it may tear.
3. REMOVE COWL LOUVERS
HINT: Pull the cowl louvers forward.
4. REMOVE WIPER LINK
a. Remove the 6 bolts.
b. Disconnect the wiper motor from the wiper link.
c. Remove the wiper link through the service hole.
5. REMOVE WIPER MOTOR
Disconnect the wire harness connector, then unfasten the 4 bolts and remove the motor.
6. REMOVE WINDOW WASHER NOZZLE
a. Remove the service hole cover.
b. Using a screwdriver, remove the window washer nozzle.
HINT: Tape the screwdriver tip before use.
c. Employ the same manner described to the other side.
INSTALLATION
1. INSTALL WINDOW WASHER NOZZLES
2. INSTALL WIPER MOTOR
3. INSTALL WIPER LINK
4. INSTALL COWL LOUVERS
5. INSTALL WEATHERSTRIP
6. INSTALL WIPER ARMS
a. Operate the wipers once and turn the wiper switch OFF.
b. Install the wiper arms and tighten the nuts by hand.
c. Adjust the installation positions of the wiper arms to the positions as shown in the illustration.
A: Approx. 40 mm (1.57 in.)
B: Approx. 65 mm (2.56 in.)
d. Torque the nuts.
Torque: 15 N.m (150 kgf.cm, 11 ft.lbf)