Canada - Wipers - Blade Replacement Procedure

Bulletin
0451

Issue Date
1995-04-01

Reference
BO-95-001

Model
4Runner; Avalon; Camry; Celica; Corolla; Land Cruiser; MR2; Paseo; Previa; Supra; T100; Tacoma; Tercel; Truck

Year Range
1991 ~ 2004

Market
Canada

Component
BO

Subject:
WIPER RUBBER REPLACEMENT PROCEDURE

The supply format of the wiper rubber has been changed. This Service Bulletin explains the replacement procedure for the new wiper rubber (squeegy).

SUPPLY FORMAT CHANGE OF WIPER RUBBER:







Difference between previous and new supply format.

Reference: Toyota Parts and Accessories News Bulletin, PNB95-004

REPLACEMENT PROCEDURE:







1. Remove blade assembly from wiper arm.

Caution: Put a shop towel or equivalent between wiper arm end and windshield to avoid damaging glass when putting wiper arm down without blade assembly.







2. Remove rubber with backing plates from frame and replace rubber (squeegy) only.

Hint: Re-use backing plates.











3. Install backing plates from previous rubber on the new rubber ( squeegy ).







Hint: The backing plates are slightly curved, so check the curvature and set them correctly on the new rubber as shown.

4. Insert rubber ( squeegy ) with backing plates into frame.
5. Install blade assembly to wiper arm.

Hint: Install the rubber head in the direction shown. .

NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.