Antitheft - Trunk Courtesy Connection Standardized
BULLETIN NUMBER:AX003-00
DATE:
March 31, 2000
TITLE:
PORT INSTALLED RS3OOO TVIP TRUNK COURTESY CONNECTION
MODELS:
'99 Camry
INTRODUCTION
The trunk courtesy connection for 1999 model year Camry vehicles equipped with a Port Installed Option RS3OOO (V3) has been relocated from the luggage compartment light switch to below the dash (lower finish panel) on the driver's side in the Instrument Panel J/B. (Refer to Illustrations A & B)
^ The location was changed to improve the installation process.
^ A splicing connector is used for the new trunk courtesy wire installation (blue) to the vehicle's wire harness at Instrument Panel J/B (red/yellow).
^ The previous location is the same as the dealer installed RS3OOO trunk courtesy connection to the luggage compartment light switch connection.
For service related purposes, this bulletin describes the procedures to locate the new trunk courtesy connection at Instrument Panel J/B in vehicles equipped with PIO RS3000.
The remote transmitter has two buttons, Top and Bottom.
The status monitor has a Toyota label, LED, and microphone.
APPLICABLE VEHICLES
1999 model year Camry vehicles equipped with PIO (V3) TVIP.
WARRANTY INFORMATION
LOCATING PROCEDURE
New Location:
These steps below are to be followed to locate the new trunk courtesy connection when servicing Camry vehicles equipped with the PIO RS3OOO TVIP
1. Remove the negative battery cable.
2. Remove the driver's step cover.
3. Remove the driver's cowl cover (1 nut).
Illustration A:
4. Locate the Connector Junction Block in the driver's cowl area. You will notice a RED/YELLOW wire routed to the Blue 10P connector which terminates at an adjacent splicing connector. This is the TVIP Trunk Courtesy Wire.
Illustration B:
5. Disconnect the Blue 10P connector from the Connector Junction Block. With the tab of the Blue 10P connector facing up, look at the back (wire side) and locate the wire in the bottom row, second space from the right, which has the splicing connector attached to it. This is the Vehicle's Trunk Courtesy Signal Wire.
6. After completing the parts inspection and repairs if applicable, reconnect the Blue 10P connector and install all previously removed parts.
Previous Location:
The White 1P connector for the Vehicle's Trunk Courtesy Signal is located at the trunk courtesy lamp switch near the trunk latch in the vehicle's trunk.