Crankshaft Position Sensor: Service and Repair

REMOVAL

1. REMOVE NO.1 TIMING BELT COVER

2. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the sensor connector
b. Disconnect the sensor connector from the generator drive belt adjusting bar.
c. Remove the bolt and sensor.

INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR
a. Install the sensor with the bolt.
Torque: 9.5 Nm (97 kgf.cm, 84 in.lbf)
b. Install the sensor connector to the generator drive belt adjusting bar.
c. Connect the sensor connector.

2. INSTALL NO.1 TIMING BELT COVER