Rear Planetary Gear

REAR PLANETARY GEAR

Components





One-Way Clutch Disassembly





1. CHECK OPERATION OF ONE-WAY CLUTCH
Hold the outer race and turn the hub. The hub should turn freely counterclockwise and should lock clockwise.





2. REMOVE THRUST WASHERS
Remove the 2 thrust washers from the both sides of planetary gear.
3. SEPARATE ONE-WAY CLUTCH AND PLANETARY GEAR





4. REMOVE ONE-WAY CLUTCH FROM OUTER RACE
a. Remove the 2 snap rings and retainers from the both sides.
b. Remove the one-way clutch from the outer race.

One-Way Clutch Assembly





1. INSTALL ONE-WAY CLUTCH
a. Install the one-way clutch into the outer race, facing the flange side of the one-way clutch toward the shiny side of the outer race.





b. Install the 2 retainers and snap rings to the both sides.





2. INSTALL PLANETARY GEAR INTO ONE-WAY CLUTCH
Install the planetary gear into the one-way clutch facing the inner race of the planetary gear toward the back side of the one-way clutch outer race.





3. CHECK OPERATION OF ONE-WAY CLUTCH





4. INSTALL THRUST WASHERS
a. Coat the 2 thrust washers with petroleum jelly.
b. Align the tab of the washers with the hollow of the carrier.

Rear Planetary Gear Inspection





- Measure Planetary Pinion Gear Thrust Clearance
Using a feeler gauge, measure the planetary pinion gear thrust clearance.

Standard clearance: 0.2 - 0.5 mm (0.008 - 0.020 inch)
Maximum clearance: 0.5 mm (0.020 inch)

If the clearance is greater than maximum, replace the planetary gear assembly.