On-Vehicle Inspection

Check the warning lights and buzzer.
1. Release parking brake lever.
2. When the ignition switch is turned ON, check that the ABS warning lights go on for 3 seconds.
3. Check the BRAKE warning light lights up when the ignition switch is turned ON and the light goes off when the engine starts.
4. When 120 seconds have elapsed after the ignition switch was turned ON, depressing and releasing the brake pedal continuously with full stroke 15 - 20 times within 10 sec. Warning light lights up and buzzer sounds.

HINT: If the indicator check result is not normal, proceed to troubleshooting for the ABS warning light circuit.







INSPECT BRAKE WARNING LIGHT
a. Disconnect the connector from the brake fluid warning switch.
b. Release the parking brake pedal.
c. Connect the terminals on the wire harness side of the 1evel warning switch connector.
d. Start the engine, check that the warning light lights up.
If the warning light does not light up, test the bulb or wire harness.