Removal and Installation

COMPONENTS

REMOVAL

1. REMOVE V-BANK COVER
2. DRAIN ENGINE COOLANT
3. REMOVE INTAKE AIR CONNECTOR
4. DISCONNECT ACCELERATOR CABLE FROM THROTTLE BODY

5. REMOVE THROTTLE BODY
a. Disconnect the throttle position sensor connector.
b. Disconnect the throttle control motor connector.
c. Disconnect the accelerator pedal position sensor connector.
d. Disconnect the accelerator pedal position sensor wire from 2 clamps on wire brackets.




e. Disconnect the PCV hose and water bypass hose from the throttle body.
f. Remove the ventilation cap.
g. Remove the 2 bolts and 2 nuts, and disconnect the throttle body from the intake manifold.




h. Disconnect the water bypass hose from the manifold thermostat on the throttle body, and remove the throttle body.
i. Remove the gasket.

INSTALLATION

1. INSTALL THROTTLE BODY




a. Connect the water bypass hose to the manifold thermostat on the throttle body.
b. Install a new gasket and the throttle body with the 2 bolts and 2 nuts.

Torque: 18 N.m (185 kgf.cm, 13 ft.lbf)




c. Install the ventilation cap.
d. Connect the water bypass hose and PCV hose to the throttle body.
e. Connect the throttle position sensor connector.
f. Connect the throttle control motor connector.
g. Connect the accelerator pedal position sensor connector.
h. Connect the accelerator pedal position sensor wire to 2 clamps on wire brackets.

2. CONNECT ACCELERATOR CABLE TO THROTTLE BODY
3. INSTALL INTAKE AIR CONNECTOR
4. FILL WITH ENGINE COOLANT
5. START ENGINE AND CHECK FOR ENGINE COOLANT LEAKS
6. INSTALL V-BANK COVER