How to Replace Terminals

Special Tool:

With terminal retainer or secondary locking device

1. Prepare The Special Tool


HINT: To remove the terminal from the connector, please construct and use the special tool or like object shown in the image.


2. Disconnect Connector




3. Disengage The Secondary Locking Device Or Terminal Retainer.
(a) Locking device must be disengaged before the terminal locking clip can be released and the terminal removed from the connector.

(b) Use a special tool or the terminal pick to unlock the secondary locking device or terminal retainer.


NOTE: Do not remove the terminal retainer from connector body.

Non-Waterproof Type Connector:

A For Non-Waterproof Type Connector


HINT: The needle insertion position varies according to the connector's shape (number of terminals etc.), so check the position before inserting it.


"Case 1"
Raise the terminal retainer up to the temporary lock position.

Non-Waterproof Type Connector:

"Case 2"
Open the secondary locking device




B For Waterproof Type Connector


HINT: Terminal retainer color is different according to connector body.


Example:
Terminal Retainer: Connector Body
Black or White : Gray
Black or White : Dark Gray
Gray or White : Black

Waterproof Type Connector:

"Case 1"
Type where terminal retainer is pulled up to the temporary lock position (Pull Type).

Insert the special tool into the terminal retainer access hole (Mark) and pull the terminal retainer up to the temporary lock position.


HINT: The needle insertion position varies according to the connector's shape (Number of terminals etc.), so check the position before inserting it.

Water-Proof Type Connector:

"Case 2"
Type which cannot be pulled as far as Power Lock insert the tool straight into the access hole of terminal retainer as shown.

Terminal Retainer:

Push the terminal retainer down to the temporary lock position.

Locking Lug:

(c) Release the locking lug from terminal and pull the terminal out from rear.

Installation Of Terminal To Connector:

4. Install terminal to connector
(a) Insert the terminal.


HINT:
1. Make sure the terminal is positioned correctly.
2. Insert the terminal until the locking lug locks firmly.
3. Insert the terminal with terminal retainer in the temporary lock position.

Secondary Locking Device:

(b) Push the secondary locking device or terminal retainer in to the full lock position.

5. Connect connector