Rear

REMOVAL
1. REMOVE REAR WHEEL

Torque: 104 Nm (1,050 kgf-cm, 77 ft. lbs.)

2. REMOVE BRAKE DRUM
3. CHECK BEARING BACKLASH AND AXLE HUB DEV11ATION





a. Set a dial indicator near the center of the axle hub and check the backlash in the bearing shaft direction.

Maximum: 0.05 mm (0.0020 inch)

If the backlash exceeds the maximum, replace the bearing.





b. Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.

Maximum: 0.07 mm (0.0028 inch)

If the deviation exceeds the maximum, replace the axle hub with the bearing.
4. DISCONNECT ABS SPEED SENSOR CONNECTOR
5. REMOVE REAR AXLE HUB
Remove the 4 nuts and rear axle hub assembly.

Torque: 80 Nm (820 kgf-cm, 59 ft. lbs.)


INSTALLATION
Installation is in the reverse order of removal.
AFTER INSTALLATION, CHECK ABS SPEED SENSOR SIGNAL