With VINS After 4T3******XU129971

If the Wiring Connector of the SRS is disconnected and the ignition switch is at ON or ACC position, DTCs will be recorded.

NOTE: Never uses the airbag parts from another vehicle. When replacing airbag system parts, always replace them with new parts.









1. Disconnect Front Passenger Airbag Assembly Connector.
a. Open the glove compartment door.
b. Using a screwdriver, remove the glove compartment door finish plate.

NOTE: When handling the Airbag Connector, take care not to damage the Airbag Wire Harness.

c. Pull the connector from the glove compartment door finish plate.
d. Disconnect the Front Passenger Airbag Assembly Connector.

2. Remove the Instrument Panel.
3. Remove the No.2 Heater to Register Duct.
Remove the 4 screws and No.2 heater to register duct from the instrument panel.






4. Remove the Front Passenger Airbag Assembly.
a. Remove the 2 bolts.






b. Pry oft the 5 Clips and remove the Front Passenger Airbag Assembly, as shown in the illustration.

NOTE: Clips are to be reused during installation.

CAUTION: Do not store the Front Passenger Airbag Assembly with the airbag deployment side facing downward. Never disassemble the Front Passenger Airbag Assembly.

c. Remove the No.1 and No.2 Safety Pad Retainers with the 2 Bolts.

5. Reassembly Front Passenger Airbag Installation is performed in the reverse order of the above Procedures Removal Procedures.