Blower Motor Switch: Service and Repair

REMOVAL




1. REMOVE CENTER CLUSTER FINISH PANEL
Using a screwdriver, release the 4 claws and pull out the panel and disconnect the connectors.

HINT: Tape the screwdriver tip before use.




2. REMOVE REAR BLOWER SWITCH
a. Pull out the switch knob.
b. Remove the 2 screws and switch.

INSTALLATION




1. INSTALL REAR BLOWER SWITCH
a. Install the switch with the 2 screws.
b. Install the switch knob.

2. INSTALL CENTER CLUSTER FINISH PANEL
Install the panel, then connect the connector.