Programming Procedure

Programming Procedure: For location of the RS3OOO ECU, refer to ECU Mounting Locations.

I. To program (add) a REMOTE CONTROL to the system:

1. Insert the key into ignition switch, and turn it to ON.






2. Press and hold the ECU's PROGRAMMING SWITCH for 3 seconds.






The STATUS MONITOR LED turns on for 5 seconds.

NOTE:
YOU MUST PERFORM THE NEXT STEP WITHIN 5 SECONDS.






3. Press and release a REMOTE CONTROL's top or bottom button*.
The STATUS MONITOR LED turns off.
The Piezo chirper chirps once.
The exterior lights flash once.

4. Turn off the ignition. The ECU will now operate with the REMOTE CONTROL just programmed.

Either button on your REMOTE CONTROL can be programmed to operate the system. The bottom button can be programmed to operate a second vehicle with the Toyota VIP.

II. To erase all REMOTE CONTROL codes from the system:
1. Insert key into the ignition switch, and turn it to ON."






2. Press and hold the ECU's PROGRAMMING SWITCH for 3 seconds.






The STATUS MONITOR LED turns on for 5 seconds.

NOTE:
YOU MUST PERFORM THE NEXT STEP WITHIN 5 SECONDS.






3. Press and hold the ECU's PROGRAMMING SWITCH for over 2 seconds again.
The STATUS MONITOR LED turns off, then flashes 3 times.
The Piezo chirper" chirps 3 times and the exterior lights flash 3 times

4.Turn off the ignition. The ECU has cleared all REMOTE CONTROL codes; until another REMOTE CONTROL is programmed, the system will not work with any REMOTE CONTROL.






ECU MOUNTING LOCATIONS