Ignition Timing: Testing and Inspection
INSPECTION1. WARM UP ENGINE
Allow the engine to warm up to normal operating temperature.
2. CONNECT TOYOTA HAND-HELD TESTER OR OBDII SCAN TOOL
a. Connect the TOYOTA hand-held tester or OBDII scan tool to the DLC3.
b. Please refer to the TOYOTA hand-held tester or OBDII scan tool operators manual for further details.
3. CHECK IGNITION TIMING
a. Using Special Service Tool (SST), connect terminals TE1 and E1 of the DLC1.
(SST) 09843-18020
HINT: After engine speed is kept at about 1,000 rpm for 5 seconds, check that it returns to idle speed.
b. Using a timing light, connect the test probe to the No.1 high-tension cord.
c. Check ignition timing.
Ignition timing: 3 - 7° BTDC @ idle
d. Remove the SST from the DLC1.
SST 09843-18020
4. FURTHER CHECK IGNITION TIMING
Ignition timing: 4 - 17° BTDC @ idle
HINT: The timing mark moves in a range between 4° and 17°.
5. DISCONNECT TOYOTA HAND-HELD TESTER OR OBDII SCAN TOOL AND TIMING LIGHT