Disassembly and Reassembly

DISASSEMBLY

1. DISCONNECT FUEL PUMP CONNECTOR
2. DISCONNECT GROUND PLATE
3. DISCONNECT FUEL SENDER GAUGE CONNECTOR

4. REMOVE FUEL SENDER GAUGE
Push down the portion of A with a finger, and push up the sender gauge.

NOTE: Be careful that the arm of the sender gauge should not bent.

5. REMOVE FUEL FILTER




a. Remove the screw, and pull out the fuel filter.
b. Remove the O-ring from the fuel filter.

HINT: At the time of installation, please refer to the following items.
Install the pump filter with a new clip.




6. REMOVE FUEL PUMP FLANGE
Using a screwdriver, remove the snap fit portion in the order of 1, 2 and 3 as shown in the illustration.

HINT: At the time of installation, please refer to the following items. Apply a light coat of gasoline to a new O-ring, and install it to the fuel filter.




7. REMOVE FUEL PUMP LEAD WIRE




8. REMOVE "C" BRACKET, RUBBER CUSHION AND FUEL PUMP
Using a screwdriver, remove the snap fit portion in the order of 1, 2 and 3 as shown in the illustration.

9. REMOVE FUEL PUMP FILTER FROM FUEL PUMP




a. Using a small screwdriver, remove the clip.
b. Pull out the pump filter.

HINT: At the time of installation, please refer to the following items.
Install the pump filter with a new clip.

REASSEMBLY
Reassembly is in the reverse order of disassembly.