Starter Signal Circuit
CIRCUIT DESCRIPTIONWhen the engine is cranked, the intake air flow is slow, so fuel vaporization is poor. A rich mixture is therefore necessary in order to achieve good startability. While the engine is being cranked, the battery positive voltage is applied to terminal STA of the ECM. The starter signal is mainly used to increase the fuel injection volume for the starting injection control and after-start injection control.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT: This diagnostic chart is based on the premise that the engine is cranked normally. If the engine is not cranked, proceed to the problem symptoms table.
Step 1:
Step 2:
TOYOTA hand-held tester
Step 1:
Step 2:
OBD II scan tool (excluding TOYOTA hand-held tester)