Problem Symptom Confirmation (Road Test)

ROAD TEST

NOTE: Do the test at normal ATF operating temperature 50 - 80 °C (122 - 176 °F).

a. D position test
Shift into the D position and keep the accelerator pedal constant at the full throttle valve opening position, and check the following points:

1. Check up-shift operation.
Check that 1 -> 2,2 -> 3 and 3 -> O/D up-shift takes place, at the shift point shown in the automatic shift schedule.

HINT:
O/D Gear Up-shift Prohibition Control
- Engine coolant temperature is 60 °C (140 °F) or less.
- If there is a 10 KPH (6 MPH) difference between the set cruise control speed and vehicle speed.
- O/D main switch is pushed ON (During the O/D OFF indicator light lights up.)

O/D Gear Lock-up Prohibition Control
- Brake pedal is depressed.
- Engine coolant temperature is 60 °C (140 °F) or less.

2. Check for shift shock and slip.
Check for shock and slip at the 1 -> 2, 2 -> 3 and 3 > O/D up-shifts.
3. Check for abnormal noise and vibration.
Run at the D position lock-up or O/D gear and check for abnormal noise and vibration.

HINT: The check for the cause of abnormal noise and vibration must be done very thoroughly as it could also be due to loss of balance in the differential, torque converter clutch, etc.

4. Check kick-down operation.
While running in the D position, 2nd, 3rd and O/D gears, check that the possible kick-own vehicle speed limits for 2 1, 3 2 and O/D -> 3 kick-downs conform to those indicated on the automatic shift schedule.
5. Check abnormal shock and slip at kick-down.
6. Check the lock-up mechanism.
- Drive in the D position, O/D gear, at a steady speed (lock-up ON) of about 70 KPH (43 MPH).
- Lightly depress the accelerator pedal and check that the RPM does not change abruptly. If there is a big jump in RPM, there is no lock-up.

b. 2 position test
Shift into the 2 position and, while driving with the accelerator pedal held constantly at the full throttle valve opening position, check on the following points:
1. Check up-shift operation.
Check that the 1 -> 2 up-shift takes place and that the shift point conforms to the automatic shift schedule.

HINT: There is no O/D up-shift and lock-up in the 2 position.

2. Check engine braking.
While running in the 2nd gear of the 2 position, release the accelerator pedal and check the engine braking effect.
3. Check for abnormal noise during acceleration and deceleration, and for shock during up-shift and down-shift.

c. L position test
Shift into the L position, check that there is no up-shift to 2nd gear.
1. Check no up-shift.
While running in the L position, check that there is no up-shift to 2nd gear.
2. Check engine braking.
While running in the L position, release the accelerator pedal and check the engine braking effect.
3. Check for abnormal noise during acceleration and deceleration.

d. R position test
Shift into the R position and while starting at full throttle, check for slipping.

CAUTION: Before conducting this test ensure that the test area is free from personnel and obstructor.

e. P position test
Stop the vehicle on a gradient (more than 5 °) and after shifting into the P position, release the parking brake.
There check that the parking lock pawl holds the vehicle in place.