Removal and Installation

REMOVAL




a. Disconnect the wire clamp from the wire clip on the rectifier end frame.
b. Remove the rubber cap and nut, and disconnect the generator wire.
c. Disconnect the generator connector.
d. Disconnect the harness clamp from the generator.




e. Loosen the 2 bolts and remove the drive belt.
f. Remove the 2 bolts and generator.

INSTALLATION




a. Install the generator and temporally tighten the 2 bolts.
b. Install the drive belt and adjust the belt tension (See On-Vehicle Inspection).
c. Tighten the 2 bolts.
Torque:
14 mm head 18 Nm (185 kg.cm, 14 ft.lb)
17 mm head 54 Nm (550 kg.cm, 40 ft.lb)
d. Connect the generator connector.
e. Connect the harness clamp.
f. Connect the generator wire, and install the nut and rubber cap.
g. Connect the generator wire, and install the rubber cap and nut.