Inspection

1. INSPECT SLIDING ROOF CONTROL RELAY AND SWITCH CIRCUIT
Disconnect the connector from the relay and switch and inspect the connector on the wire harness side, as shown in the chart.




If the circuit is as specified, replace the relay and switch.

2. INSPECT SLIDING ROOF MOTOR OPERATION




a. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, check that the motor turns counterclockwise (for closing and raising operations) -




b. Reverse the polarity, check that the motor turns clockwise (for opening and lowering operations).
If operation is not as specified, replace the motor.




3. INSPECT SLIDING ROOF LIMIT SWITCH CONTINUITY




If continuity is not as specified, replace the switch.




4. INSPECT SLIDING ROOF MOTOR AND LIMIT SWITCH CIRCUIT
Disconnect the connector from the limit switch and inspect the connector on the wire harness side.




If the circuit is not as specified, inspect the circuits connected to other parts.

5. INSPECT CIRCUIT BREAKER OPERATION




a. With the sliding root in the fully opened position, hold the sliding roof switch in "OPEN" position and check that there is a circuit breaker operation noise within 10 to 60 seconds.





b. With the sliding roof in fully opened position, hold the sliding roof switch in "TILT UP" position and check that the sliding roof begins to close within 60 seconds.
If operation is not as specified, replace the motor.

6. INSPECT KEY-OFF SLIDING ROOF OPERATION