Removal and Installation

REMOVAL





1. DISCONNECT FLEXIBLE HOSE
a. Remove the union bolt and disconnect the flexible hose.
Torque: 30 Nm (310 kgf-cm, 22 ft. lbs.)

NOTICE: At the time of installation, for correct brake hose routing, ensure that the hose hangs down before installing hose to caliper.

b. Use a container to catch the brake fluid.
2. REMOVE CALIPER FROM TORQUE PLATE
Remove the 2 slide pins and caliper.
Torque: 88 Nm (900 kgf-cm, 65 ft. lbs.)
3. REMOVE 2 BRAKE PADS WITH 4 ANTI-SQUEAL SHIMS AND PAD WEAR INDICATOR
4. REMOVE 4 PAD SUPPORT PLATES

INSTALLATION
Installation is in the reverse order of removal.

HINT: After installation, fill the brake reservoir with brake fluid, bleed brake system and check for leaks.
Brake Bleeding