Removal and Installation

REMOVAL
1. REMOVE BRAKE LINE COVER





2. DISCONNECT CONNECTOR
Pull out the release bar, and disconnect the connector.





3. DISCONNECT BRAKE LINES
Using SST, disconnect the 5 brake lines from the ABS actuator.
SST 09023-00100
Torque: 15 Nm (155 kgf-cm, 11 ft. lbs.)
4. REMOVE ABS ACTUATOR ASSEMBLY
Remove the bolt, 2 nuts and ABS actuator assembly.
Torque: 19 Nm (195 kgf-cm, 14 ft. lbs.)
5. REMOVE ABS ACTUATOR
Using a T25 torx wrench, remove the 3 bolts and ABS actuator from actuator bracket.
Torque: 9.0 Nm (91.8 kgf-cm, 80 inch lbs.)


INSTALLATION
Installation is in the reverse order of removal.

HINT: After installation, fill the brake reservoir with brake fluid, bleed brake system and check for leaks.
Brake Bleeding