Refrigerant Pressure Sensor / Switch: Service and Repair

REMOVAL

1. REMOVE EVAPORATOR




2. REMOVE PRESSURE SWITCH FROM LIQUID TUBE
Disconnect the connector and remove the pressure switch.

Torque: 10 Nm (100 kg.cm, 7 ft.lb)

HINT:
- Lock the switch mounted on the tube with an open end wrench, being careful not to deform the tube and remove the switch.
- At the time of installation, please refer to the following item.
Lubricate a new O-ring with the compressor oil and install the switch.

INSTALLATION
Installation is in the reverse order of removal.