Without Differential Lock

REMOVAL

Part 1 Of 2:

Part 2 Of 2:

HINT: PreRunner is the model described below.
RZN191L-TRPDKAB, RZN196L-CRPDKAB, VZN195L-CRPDKAB

1. DRAIN HYPOID GEAR OIL
2. REMOVE REAR AXLE SHAFTS
3. DISCONNECT REAR PROPELLER SHAFT
4. REMOVE DIFFERENTIAL CARRIER ASSEMBLY
a. Remove the 10 nuts, washers and differential carrier assembly.

NOTICE: Be careful not to damage the installation surface.

Torque: 73 Nm (740 kgf-cm, 54 ft. lbs.)
b. Remove the gasket.

INSTALLATION
Installation is in the reverse order of removal.

HINT: After installation, fill the differential with hypoid gear oil.