Canada - Fuel System - No Start Condition

Bulletin
TSB2253

Issue Date
2005-06-09

Market
Canada

Title
2UZ-FE ENGINE "NO START" CONDITION

Component
ENGINE ELECTRICAL

Models
'00 - '02 Tundra (2UZ FE) & '01 - '02 Sequoia

INTRODUCTION:
Some 2000 - 2002 model year Tundra trucks (2UZ FE) and 2001 - 2002 Sequoia vehicles may exhibit an engine "no start" condition. This may be caused by an inoperative fuel pump and/or blown EFI fuse. The Fuel Pump Assembly and Pick up Sock have been improved to correct this condition.

APPLICABLE VEHICLES:
- 2000 - 2002 model year Tundra vehicles with 2UZ-FE engines produced BEFORE the Production Change Effective VIN shown below.
- 2001 - 2002 model year Sequoia vehicles produced BEFORE the Production Change Effective VIN shown below.






PRODUCTION CHANGE INFORMATION:






PARTS INFORMATION:






WARRANTY INFORMATION:

REPAIR PROCEDURE:
Refer to the appropriate Repair Manual and Electrical Wiring Diagram (EWD) publication to confirm the inoperative fuel pump and/or blown EFI fuse before replacing any components.

Once confirmed, use the following procedures to install the appropriate Fuel Pump Kit.

For Tundra:






Using the supplied parts, assemble the Fuel Pump, Pick-up Sock and Fuel Pump Hose and install it on the existing Suction Plate/Bracket.

For Sequoia:






Using the supplied parts, assemble the Fuel Pump, Pick-up Sock and Fuel Pump Hose and longer wire harness. Install the assembly on the existing Suction Plate/Bracket.

NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.