System Inspection

INSPECTION

1. INSPECT SLIDING ROOF MOTOR CONTINUITY




a. Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1, and check that the motor turns clockwise.




b. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, and check that the motor turns counterclockwise.
If the operation is not as specified, replace the motor.







2. INSPECT SLIDING ROOF CONTROL RELAY CIRCUIT
Disconnect the connector from the relay and inspect the connector on the wire harness side.







3. INSPECT LIMIT SWITCH CONTINUITY
If the continuity is not as specified, replace the switch.





INSPECT SLIDING ROOF GLASS ALIGNMENT
a. Start the engine and check the operation time of the sliding roof.
Operation time: Approx. 5 sec.
b. Check for abnormal noise or binding during operation.
c. With the sliding roof fully closed, check for water leakage.
d. Check for a difference in level between the sliding roof weatherstrip and roof panel.
Front end: 0 ± 1.5 mm (0 ± 0.059 in.)
Rear end: 0 ± 1.5 mm (0 ± 0.059 in.)