Starter Signal Circuit

CIRCUIT DESCRIPTION

Wiring Diagram:

When the engine is cranked, the intake air flow is slow, so fuel vaporization is poor. A rich mixture is therefore necessary in order to achieve good startability. While the engine is being cranked, the battery positive voltage is applied to terminal STA of the ECM. The starter signal is mainly used to increase the fuel injection volume for the starting injection control and after-starter injection control.

Step 1:

INSPECTION PROCEDURE

Step 2:

TOYOTA hand-held tester:

Steps 1 - 2:

OBD II scan tool (excluding TOYOTA hand-held tester):

HINT: This diagnostic chart is based on the premise that the engine is cranked normally. If the engine is not cranked, proceed to the problem symptoms table.