Operation CHARM: Car repair manuals for everyone.

Speed Sensor, Front






REMOVAL
REMOVE SPEED SENSOR
a. Disconnect the speed sensor connector.
b. Remove the 4 resin clips and 3 clamp bolts holding the sensor harness from the steering knuckle, upper arm and side rail.
Torque:
Steering knuckle and upper arm: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
Side rail: 12 Nm (122 kgf-cm, 9 ft. lbs.)





c. Remove the speed sensor installation bolt from the steering knuckle.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
- There are no foreign objects on the sensor or the part of the knuckle to which the sensor is to be Installed.
- The sensor is installed flat against the knuckle when you tighten the bolt.

HINT: After installation, check the speed sensor signal.